Tipping bucket rain gauge sensor rainfall meter for weather station RS485 output cheap

The rainfall sensor (transmitter) is suitable for relevant departments such as meteorological platforms (stations), hydrological stations, agriculture and forestry, national defense, etc., which is used to remotely measure liquid precipitation, precipitation intensity, and precipitation.

The rainfall sensor can be used to prevent flood prevention, water supply scheduling, power station reservoir hydrophilic management, etc., and hydrological automatic reporting systems and automatic field measurement stations.

Installation Notes

1. The installation location of the sensor can be selected on the ground, homemade large barrel, iron pillar flange or roof;

2. Adjust the three flat screws on the chassis to make the level foam instructions horizontally (the bubbles stay in the center of the circle), and then slowly tighten the fixed expansion screws of the three M8 × 80; It

3. After fixing, turn on the rainfall barrel, cut off the nylon tie on the funnel, slowly inject the water into the rainfall sensor, and observe the turning turning process to check whether the data is received on the collection instrument. Finally, inject quantitative water (60-70mm). If the data displayed by the collection instrument is consistent with the amount of injection water, it means that the instrument is normal, otherwise it must be maintained and adjusted;

4. Please avoid disassembling the sensor during installation.

Precautions                              

1. Do not bring a power wiring. After the wiring is checked, you can power on the incorrectly;

2. The length of the sensor line will affect the output signal of the product. Do not change the product or wire that has been welded when the product leaves the factory when using it. If there is a change in need, please contact the manufacturer;

3. The sensor should be checked regularly to remove dust, mud, leaves, and insects to avoid blocking the upper cylinder (funnel) water flow channel.

4. The inner wall of the over turning in the wall is dirty, and it can be rinsed with water or alcohol or detergent aqueous solution. It is strictly forbidden to wipe with your fingers or other objects to avoid staining oil or abrasive inner walls;

5. During winter freezing, the instrument should be stopped, and it can be returned to the room;

Rainfall and crop growth and development are closely related, it can be said that the monitoring of rainfall is very important, rainfall monitoring equipment with alarm function, to reach the corresponding level will automatically alarm, you can monitor the rainfall hydrological elements in real time.

"As an important basic data support for flood prevention and mitigation, timely and accurate provision of water and rainfall at the site, effectively and efficiently improve the level and efficiency of monitoring and early warning.

Rainfall monitoring station , mainly by the stainless steel rainfall sensor, collector, solar power supply system, vertical pole support, etc., the meteorological department through it to monitor the measurement of rainfall and rainfall intensity, the data is relatively accurate, so it is widely used in agricultural meteorological monitoring.

Tipping bucket rain gauge data sheet

NBL-W-ARS-Tipping-bucket-rain-gauge-instruction-manual.pdf

NBL-W-RS-Rain-sensors-instruction-manual-V4.0.pdf